.
.
Download / Read Online Kenmore through the wall air conditioner manual
.
.
.

.
INSTALLATION MANUAL This manual provides the procedures of installation to ensure a safe and good standard of operation for the air conditioner unit. Special adjustment may be necessary to suit local requirement. Before using your air conditioner, please read this instruction manual carefully and keep it for future reference. This appliance is intended to be used by expert or trained users in shops, in light industry and on farms, or for commercial use by lay persons. This appliance is not intended for use by persons, including children, with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance. CAUTION Installation and maintenance should be performed by qualified persons who are familiar with local code and regulation, and experienced with this type of appliance. All field wiring must be installed in accordance with the national wiring regulation. Ensure that the rated voltage of the unit corresponds to that of the name plate before commencing wiring work according to the wiring diagram. The unit must be GROUNDED to prevent possible hazard due to insulation failure. All electrical wiring must not touch the water piping or any moving parts of the fan motors. Confirm that the unit has been switched OFF before installing or servicing the unit. Disconnect from the main power supply before servicing the air conditioner unit. DO NOT pull out the power cord when the power is ON. This may cause serious electrical shocks which may result in the fire hazards. Keep the indoor and outdoor units, power cable and transmission wiring, at least 1m from TVs and radios, to prevent distorted pictures and static. Please take note of the following important points when installing. Ensure that drainage piping is connected properly. If the drainage piping is not connected properly, it may cause water leakage which will dampen the furniture. Ensure that the unit s panel is closed after service or installation. Unsecured panels will cause the unit to operate noisily. Sharp edges and coil surfaces are potential locations which may cause injury hazards. Avoid from being in contact with these places. If this is not done, the unit s fans will start turning automatically when power resumes, posing a hazard to service personnel or the user. Do not install the units at or near doorway. Do not operate any heating apparatus too close to the air conditioner unit or use in room where mineral oil, oil vapour or oil steam exist, this may cause plastic part to melt or deform as a result of excessive heat or chemical reaction. When the unit is used in kitchen, keep flour away from going into suction of the unit. This unit is not suitable for factory used where cutting oil mist or iron powder exist or voltage fluctuates greatly. Do not install the units at area like hot spring or oil refinery plant where sulphide gas exists. Ensure the color of wires of the outdoor unit and the terminal markings are same to the indoors respectively. DO NOT INSTALL OR USE THE AIR CONDITIONER UNIT IN A LAUNDRY ROOM. Don t use joined and twisted wires for incoming power supply. The equipment is not intended for use in a potentially explosive atmosphere. Disposal requirements Your air conditioning product is marked with this symbol. This means that electrical and electronic products shall not be mixed with unsorted household waste. By ensuring this product is disposed of correctly, you will help to prevent potential negative consequences for the environment and human health. Please contact the installer or local authority for more information. Batteries must be removed from the remote controller and disposed of separately in accordance with relevant local and national legislation. IMPORTANT Important information regarding the refrigerant used This product contains fluorinated greenhouse gases covered by the Kyoto Protocol. Do not vent gases into the atmosphere. Global Warming Potential English Please fill in with indelible ink, 1 the factory refrigerant charge of the product, 2 the additional refrigerant amount charged in the field and the total refrigerant charge on the refrigerant charge label supplied with the product. Periodical inspections for refrigerant leaks may be required depending on European or local legislation. Please contact your local dealer for more information. INSTALLATION DIAGRAM Indoor Unit Front panel 30mm or more from ceiling Caulk pipe hole gap with putty. Cut thermal insulation pipe to an appropriate length and wrap it with tape, making sure that no gap is left in the insulation pipe s cut line. Wrap the insulation pipe with the finishing tape from bottom to top. Pull out the service lid diagonally down in the direction of the arrow. Where a wall or other obstacle is in the path of outdoor unit s intake filexlib.
.
Kenmore through the wall air conditioner manuel
Kenmore through the wall air conditioner user guide
Kenmore through the wall air conditioner guide
Kenmore through the wall air conditioner handboek
Kenmore through the wall air conditioner handbog